toad.social is one of the many independent Mastodon servers you can use to participate in the fediverse.
Mastodon server operated by David Troy, a tech pioneer and investigative journalist addressing threats to democracy. Thoughtful participation and discussion welcome.

Administered by:

Server stats:

240
active users

#bigtreetech

0 posts0 participants0 posts today

Always interesting. If I want to buy something from #Bigtreetech / #BIQU, I put it in my shopping basket and leave it there for the time being.

A few days later I get a reminder to complete the purchase after all, together with a 5% coupon code. And if I leave it further, sometimes I even get a 10% coupon code.

Every time. 😃

For three months now, I've had a #P1S in addition to my #BambuLab #X1C. I've had the Panda Touch Display from #BigTreeTech since January of this year. It's a great device. But now it's time to find its place on the P1S.

For this purpose, I have designed a dock that can be tilted with a hinge, similar to the one on the X1C. I have missed this feature in all the docks and mounts that have been available so far.

#3DPrint #3DPrinting #3DDesign #Shapr3D #3DModeling

collaborate.shapr3d.com/v/Bt5b

collaborate.shapr3d.comShapr3D WebviewerShare your designs with a single click.
I got stuck, troubleshooting my #BTT #BigTreeTech #Octopus 1.1 mainboard, installed in newly assembled #RatRig #V-core #3Dprinter, running #RatOS aka #Klipper.

Both #nozzle (#extruder) #heater and #hotbed one do not warm up. Beyond all doubt (using external power sources and hairdryer) I confirmed that both thermistors, heaters and wiring are ok.

Under warranty, RatRig sent me replacement board, which I configured, flashed with updated firmware and got the same error.
I also tried to redirect the nozzle heater power to another pin (see in the config file at lib.tepewu.pl/f/8f1d29fe05d44c…) where I hooked up the multimeter. Nothing happened, when I set up nozzle temp to 50*C - after timeout I had the same error "extruder is not heating fast enough", thus klipper shutdown.

I cannot believe to have such a bad luck to got two boards with the same hardware fault (especially that steppers and hotbed probe work perfectly), so it is something I do not know - and I run out of ideas.

Please, somebody suggest something new. Hjalp.
Czytelniaprinter.cfgShare link for printer.cfg.

#Reddit has a recap for users. I did actually use the site more this year than before so I decided to take a look.

I spent the most time on these topics:
#HollowKnight (first video game I've played in years).
Mastodon (setting up my instance)
#BigTreeTech (updating my #3dPrinter)

My top comment was about how the #Scrubs podcast didn't acknowledge Victoria Tennant as a guest star.

My most popular post was:
"Headless calibre-server and multiple libraries"